At least 280,000 hip fractures occur annually in the U.S., at an estimated cost of $9 billion. While over 90 percent of these are caused by falls, only about 2 percent of all falls result in hip fracture. Evidence suggests that the most important determinants of hip fracture risk during a fall are the body’s impact velocity and configuration. Accordingly, protective responses for reducing impact velocity, and the likelihood for direct impact to the hip, strongly influence fracture risk. One method for reducing the body’s impact velocity and kinetic energy during a fall is to absorb energy in the lower extremity muscles during descent, as occurs during sitting and squatting. In the present study, we employed a series of inverted pendulum models to determine: (a) the theoretical effect of this mechanism on impact severity during a backward fall, and (b) the effect on impact severity of age-related declines (or exercise-induced enhancements) in lower extremity strength. Compared to the case of a fall with zero energy absorption in the lower extremity joints, best-case falls (which involved 81 percent activation of ankle and hip muscles, but only 23 percent activation of knees muscles) involved 79 percent attenuation (from 352 J to 74 J) in the body’s vertical kinetic energy at impact and 48 percent attenuation (from 3.22 to 1.68 m/s) in the downward velocity of the pelvis at impact Among the mechanisms responsible for this were: (1) eccentric contraction of lower extremity muscles during descent, which resulted in up to 150 J of energy absorption; (2) impact with the trunk in an upright configuration, which reduced the change in potential energy associated with the fall by 100 J; and (3) knee extension during the final stage of descent, which “transferred” up to 90 J of impact energy into horizontal (as opposed to vertical) kinetic energy. Declines in joint strength reduced the effectiveness of mechanisms (1) and (3), and thereby increased impact severity. However, even with reductions of 80 percent in available torques, was attenuated by 50 percent. This indicates the importance of both technique and strength in reducing impact severity. These results provide motivation for attempts to reduce elderly individuals’ risk for fall-related injury through the combination of instruction in safe falling techniques and exercises that enhance lower extremity strength.
Skip Nav Destination
Article navigation
December 2001
Technical Papers
An Analysis of the Effect of Lower Extremity Strength on Impact Severity During a Backward Fall
Reuben Sandler,
Reuben Sandler
Biomechanics Laboratory, Department of Orthopaedic Surgery, San Francisco General Hospital and University of California, San Francisco, San Francisco, CA 94110
Search for other works by this author on:
Stephen Robinovitch
Stephen Robinovitch
Biomechanics Laboratory, Department of Orthopaedic Surgery, San Francisco General Hospital and University of California, San Francisco, San Francisco, CA 94110
Search for other works by this author on:
Reuben Sandler
Biomechanics Laboratory, Department of Orthopaedic Surgery, San Francisco General Hospital and University of California, San Francisco, San Francisco, CA 94110
Stephen Robinovitch
Biomechanics Laboratory, Department of Orthopaedic Surgery, San Francisco General Hospital and University of California, San Francisco, San Francisco, CA 94110
Contributed by the Bioengineering Division for publication in the JOURNAL OF BIOMECHANICAL ENGINEERING. Manuscript received by the Bioengineering Division July 2, 1999; revised manuscript received May 16, 2001. Associate Editor: M. G. Pandy.
J Biomech Eng. Dec 2001, 123(6): 590-598 (9 pages)
Published Online: May 16, 2001
Article history
Received:
July 2, 1999
Revised:
May 16, 2001
Citation
Sandler , R., and Robinovitch, S. (May 16, 2001). "An Analysis of the Effect of Lower Extremity Strength on Impact Severity During a Backward Fall ." ASME. J Biomech Eng. December 2001; 123(6): 590–598. https://doi.org/10.1115/1.1408940
Download citation file:
Get Email Alerts
Related Articles
An Efficient and Accurate Prediction of the Stability of Percutaneous Fixation of Acetabular Fractures With Finite Element Simulation
J Biomech Eng (September,2011)
Use of Virtual, Interactive, Musculoskeletal System (VIMS) in Modeling and Analysis of Shoulder Throwing Activity
J Biomech Eng (June,2005)
A Musculoskeletal Model of the Equine Forelimb for Determining Surface Stresses and Strains in the Humerus—Part II. Experimental Testing and Model Validation
J Biomech Eng (August,2008)
The Axial Injury Tolerance of the Human Foot/Ankle Complex and the Effect of Achilles Tension
J Biomech Eng (December,2002)
Related Proceedings Papers
Related Chapters
Effect of Metallurgical Parameters on Hydrogen Absorption and Delayed Fracture in Martensitic Press Hardened Steels
International Hydrogen Conference (IHC 2016): Materials Performance in Hydrogen Environments
DEVELOPMENTS IN STRAIN-BASED FRACTURE ASSESSMENTS - A PERSPECTIVE
Pipeline Integrity Management Under Geohazard Conditions (PIMG)
Simulation of the Fracture Network in the Inter-Bed Layered Rock Masses
Geological Engineering: Proceedings of the 1 st International Conference (ICGE 2007)