Abstract
This paper describes the development and results of a tension-tension fatigue life test program. The fatigue life of a quasi-isotropic graphite/epoxy laminate was experimentally measured at three temperatures: −195°C, 22°C, and 121°C. To perform testing at these temperatures a supplemental gripping fixture and a cold cell were designed and manufactured. Issues addressed during the test program include failure of the gripping system, grip-induced failure of the test laminate, and temperature stability. The test results showed that the test laminate’s nominal fatigue life improved when tested at −195°C, and decreased when tested at 121°C.
Issue Section:
Research Papers
References
1.
Boyd
, R. H.
and Phillips
, P. J.
, “The Science of Polymer Molecules
,” Cambridge University Press
, Cambridge, Great Britain
, 1993
.2.
Miyano
, Y.
, Nakada
, M.
, McMurray
, M.
, and Muki
, R.
, “Prediction of Flexural Fatigue Strength of CFRP Composites under Arbitrary Frequency, Stress Ratio and Temperature
,” Journal of Composite Materials
, Vol. 31
, No. 6
, 1997
, pp. 619
-638
.3.
McMurray
, M. K.
, Enyama
, J.
, Nakasa
, M.
, and Miyano
, Y.
, “Loading Rate and Temperature Dependance on Flexural Fatigue Behavior of a Satin Woven CFRP Laminate
,” Proceedings of the 38th International SAMPE Symposium
, May, 1993, pp. 1944
-1956
.4.
Ambur
, D. R.
, Sikora
, J.
, Maguire
, J.
, and Winn
, P. M.
, “Development of A Pressure Box To Evaluate Reusable-Launch-Vehicle Cryogenic-Tank Panels
,” Proceedings of the 37th AIAA/ASME/ASCE/AHS/ASC Structures, Structural Dynamics, and Materials Conference
, 04
1996
.5.
“
Standard Test Method for Tension-Tension Fatigue of Polymer Matrix Composite Materials
,” Designation
D-3479, Annual Book of ASTM Standards Vol. 15.03, 1998
.6.
Reifsnider
, K. L.
, “Damage and Damage Mechanics
,” in Fatigue of Composite Materials
, K. L.
Reifsnider
, Ed., Elsevier
, New York, New York
, 1991
.7.
Talreja
, Ramesh
, Fatigue of Composite Materials
, Technomic Inc.
, 1987
.
This content is only available via PDF.
All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, film, or other distribution and storage media, without the written consent of ASTM International.
You do not currently have access to this content.