Predicting erosion resulting from the impact of solid particles such as sand is a difficult task, since it is dependent on so many factors. The difficulty is compounded if the particles are entrained in multiphase flow. Researchers have developed models to predict erosion resulting from solid particles in multiphase flow that account for a variety of factors. However, no model currently accounts for the flow orientation on the severity of erosion. This work provides three sets of experimental results that demonstrate pipe orientation can have a significant impact on the amount of erosion for annular flow. A semimechanistic model to predict erosion in annular flow is also outlined that accounts for the upstream flow orientation.
Issue Section:
Petroleum Transport/Pipelines/Multiphase Flow
Keywords:
erosion,
multiphase flow,
pipe flow,
pipes,
rotational flow,
sand,
annular flow,
erosion,
sand
References
1.
American Petroleum Institute, API Recommended Practice for Design and Installation of Offshore Production Platform Piping Systems. API RP 14E, American Petroleum Institute, 5th ed., Washington D.C. (1991)
2.
Salama
, M.
, 1993, “Erosion Velocity Limits for Water Injection Systems
,” Mater. Perform.
, 32
(7
), pp. 44
–49
.3.
Jordan
, K.
, 1998, “Erosion in Multiphase Production of Oil and Gas. Corrosion 98
, NACE International Annual Conference
, San Antonio, TX
, Paper No. 58.4.
Salama
, M.
, and Venkatesh
, E.
, 1983, “Evaluation of Erosional Velocity Limitations in Offshore Gas Wells
,” Proceedings of 15th Offshore Technology Conference
, Houston
, Paper No. OTC-4485.5.
Svedeman
, S.
, and Arnold
, K.
, 1993, “Criteria for Sizing Multiphase Flow Lines for Erosive/Corrosive Service
,” Proceedings of 68th SPE Annual Fall Technical Conference
, Houston
, Paper No. SPE-26569.6.
Weiner
, P.
, and Tolle
, G.
, 1976, “Detection and Prevention of Sand Erosion of Production Equipment
,” API OSAPER Project No. 2
, American Petroleum Institute
, Texas A&M Research Foundation
.7.
Bourgoyne
, A.
, 1989, “Experimental Study of Erosion in Diverter Systems Due to Sand Production
,” Proceedings of SPE/IADC Drilling Conference
, LA
, Paper No. SPE/IADC-18716.8.
Shirazi
, S. A.
, McLaury
, B. S.
, Shadley
, J. R.
, and Rybicki
, E. F.
, 1995, “A Procedure to Predict Solid Particle Erosion in Elbows and Tees
,” J. Pressure Vessel Technol.
, 117
(1
), pp. 45
–52
.9.
McLaury
, B. S.
, and Shirazi
, S. A.
, 2000, “An Alternate Method to API RP 14E for Predicting Solids Erosion in Multiphase Flow
,” ASME J. Energy Resour. Technol.
, 122
(3
), pp. 115
.10.
Mazumder
, Q. H.
, Shirazi
, S. A.
, and McLaury
, B. S.
, 2004, “A Mechanistic Model to Predict Sand Erosion in Multiphase Flow in Elbows Downstream of Vertical Pipes
,” Corrosion
, 2004, Paper No. 04662.11.
Mazumder
, Q. H.
, 2004, Development and Validation of a Mechanistic Model to Predict Erosion in Single-Phase and Multiphase Flow
. Ph.D. Dissertation, Department of Mechanical Engineering, The University of Tulsa, Tulsa, OK.12.
Salama
, M. M.
, 1998, “An Alternative to API 14E Erosional Velocity Limits for Sand Laden Fluids
,” Proceedings of Offshore Technology Conference
, Houston
, Paper No. OTC-8898.13.
Det Norske Veritas, 1996, “
Recommended Practice, Erosion Wear of Piping Systems
,” DNV RP O501
.14.
Forder
, A.
, Thew
, M.
, and Harrison
, D.
, 1998, “Numerical Investigation of Solid Particle Erosion Experienced Within Oilfield Control Valves
,” Wear
, 216
, pp. 184
–184
.15.
Huser
, A.
, and Kvernvold
, O.
, 1998, “Prediction of Sand Erosion in Process and Pipe Components
,” Proceedings 1st North American Conference on Multiphase Technology
, Banff, Canada, BHR group Conference Series Publication No. 31
.16.
Edwards
, J. K.
, McLaury
, B. S.
, and Shirazi
, S. A.
, 2001, “Modeling Solid Particle Erosion in Elbows and Plugged Tees
,” ASME J. Energy Resour. Technol.
, 123
(4
), pp. 277
.17.
Chen
, X.
, 2004, “Application of Computational Fluid Dynamics (CFD) to Flow Simulation and Erosion Prediction in Single-Phase and Multiphase Flow
,” Ph.D. Dissertation, Department of Mechanical Engineering, The University of Tulsa, Tulsa, OK.18.
Santos
, G.
, 2002, “Effect of Sand Distribution on Erosion and Correlation between Acoustic Sand Monitor and Erosion Test in Annular Multiphase Flow
,” M.S. Thesis, Department of Mechanical Engineering, The University of Tulsa, Tulsa, OK.19.
Viswanathan
, V.
, 2004, “Effect of Flow Orientation and Estimated Particle Impact Velocities on Acoustic Sand Sensor Output
,” M. S. Thesis, Department of Mechanical Engineering, The University of Tulsa, Tulsa, OK.20.
Williams
, L. R.
, Dykhno
, L. A.
, and Hanratty
, T. J.
, 1996, “Droplet Flux Distributions and Entrainment in Horizontal Gas-Liquid Flows
,” Int. J. Multiphase Flow
, 22
(1
), pp. 1
–18
.21.
Fore
, L. B.
, and Dukler
, A.
, 1994, “The Distribution of Drop Size and Velocity in Gas-Liquid Annular Flow
,” Int. J. Multiphase Flow
, 21
(2
), pp. 137
–149
.22.
Ishii
M.
and Mishima
, K.
, 1989, “Droplet Entrainment Correlation in Annular Two Phase Flow
,” Int. J. Heat Mass Transfer
, 12
(10
), pp. 1835
–1846
.23.
Paz
, R. J.
, and Shoham
, O.
, 1994, “Film Thickness Distribution for Annular Flow in Directional Wells – Horizontal to Vertical
,” SPE Annual Technical Conference and Exhibition, SPE 28541
.Copyright © 2011
by American Society of Mechanical Engineers
You do not currently have access to this content.