Abstract

Methods for physically stabilizing the extremely fragile ashed teeth that are often encountered in incinerated human remains were investigated.

Results of a questionnaire sent to forensic anthropologists and forensic odontologists disclosed that, for these two groups, the most popular methods currently used are impregnation with a solution of polyvinyl acetate or application of cyanoacrylate cement, respectively.

In addition, extracted human teeth were incinerated in the laboratory and impregnated with commercially available preparations of either cyanoacrylate cement, clear acrylic spray paint, hair spray, spray furniture varnish, clear fingernail polish, quick-setting epoxy cement. Duco® household cement, polyvinyl acetate polymer in acetone, or self-curing clear dental acrylic resin. Every substance tested successfully stabilized the incinerated teeth. Clear acrylic spray paint was judged the most efficacious overall because of its ease of application, availability, inexpensiveness, and rapidity of setting.

Issue Section:
Technical Notes
Keywords:
odontology, human identification, dentition

References

1.
Gustafson
,
G.
,
Forensic Dentistry
,
Elsevier
,
New York
,
1966
, p. 185.
2.
Caldwell
,
P. C.
, “
Appendix A: The Human Remains Recovered in the San Carlos River Valley Excavations
,”
Mogollon, Hohokam and Western Pueblo Settlement and Subsistence in the San Carlos River Valley, San Carlos, Arizona
,
K.
 
Ditzler
, Ed.,
Archaeological Research Services
,
Tempe, AZ
,
1981
, pp.
2
-
3
.
3.
Ritchie
,
W.
, “
Incineration Oral Exam Methods and an I.D. Picture for the Jury
,” paper presented at the
39th Annual Meeting of the American Academy of Forensic Sciences
,
San Diego, CA
, 16–21 Feb. 1987.
4.
Fox
,
S. C.
, “
Stabilization of Fire-Damaged Teeth: A Technique Utilizing Polyvinyl Acetate Resin
,” paper presented at the
39th Annual Meeting of the American Academy of Forensic Sciences
,
San Diego, CA
, 16–21 Feb. 1987.
This content is only available via PDF.
All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, film, or other distribution and storage media, without the written consent of ASTM International.
You do not currently have access to this content.