This work explores a comparative study of different methods of using animal fat as a fuel in a compression ignition engine. A single-cylinder air-cooled, direct-injection diesel engine is used to test the fuels at 100% and 60% of the maximum engine power output conditions. Initially, animal fat is tested as fuel at normal temperature. Then, it is preheated to and used as fuel. Finally, animal fat is converted into methanol and ethanol emulsions using water and tested as fuel. A drop in cylinder peak pressure, longer ignition delay, and a lower premixed combustion rate are observed with neat animal fat as compared to neat diesel. With fat preheating and emulsions, there is an improvement in cylinder peak pressure and maximum rate of pressure rise. Ignition delay becomes longer with both the emulsions as compared to neat fats. However, preheating shows shorter ignition delay. Improvement in heat release rates is achieved with all the methods as compared to neat fats. At normal temperature, neat animal fat results in higher specific energy consumption and exhaust gas temperature as compared to neat diesel at both power outputs. Preheating and emulsions of animal fat show improvement in performance as compared to neat fat. Smoke is lower with neat fat as compared to neat diesel. It reduces further with all the methods. At peak power output, the smoke level is found as with methanol, with ethanol emulsions, and with fat preheating, whereas it is with neat fat and with neat diesel. Methanol and ethanol emulsions significantly reduce NO emissions due to the vaporization of water and alcohols. However, NO increases with fat preheating due to high in-cylinder temperature. Higher unburned hydrocarbon and carbon monoxide emissions are found with neat fat as compared to neat diesel at both power outputs. However, these emissions are considerably reduced with all the methods. It is finally concluded that adopting emulsification with the animal fat can lead to a reduction in emissions and an improvement in combustion characteristics of a diesel engine.
Skip Nav Destination
e-mail: Jerome.bellettre@emn.fr
Article navigation
October 2006
Technical Papers
A Comparative Study of Different Methods of Using Animal Fat as a Fuel in a Compression Ignition Engine
M. Senthil Kumar,
M. Senthil Kumar
Département Systèmes Energétiques et Environnement,
Ecole des Mines de Nantes
, 4 rue Alfred Kastler, BP 10722, 44307 Nantes, Cedex 03, France
Search for other works by this author on:
A. Kerihuel,
A. Kerihuel
Département Systèmes Energétiques et Environnement,
Ecole des Mines de Nantes
, 4 rue Alfred Kastler, BP 10722, 44307 Nantes, Cedex 03, France
Search for other works by this author on:
J. Bellettre,
J. Bellettre
Département Systèmes Energétiques et Environnement,
e-mail: Jerome.bellettre@emn.fr
Ecole des Mines de Nantes
, 4 rue Alfred Kastler, BP 10722, 44307 Nantes, Cedex 03, France
Search for other works by this author on:
M. Tazerout
M. Tazerout
Département Systèmes Energétiques et Environnement,
Ecole des Mines de Nantes
, 4 rue Alfred Kastler, BP 10722, 44307 Nantes, Cedex 03, France
Search for other works by this author on:
M. Senthil Kumar
Département Systèmes Energétiques et Environnement,
Ecole des Mines de Nantes
, 4 rue Alfred Kastler, BP 10722, 44307 Nantes, Cedex 03, France
A. Kerihuel
Département Systèmes Energétiques et Environnement,
Ecole des Mines de Nantes
, 4 rue Alfred Kastler, BP 10722, 44307 Nantes, Cedex 03, France
J. Bellettre
Département Systèmes Energétiques et Environnement,
Ecole des Mines de Nantes
, 4 rue Alfred Kastler, BP 10722, 44307 Nantes, Cedex 03, Francee-mail: Jerome.bellettre@emn.fr
M. Tazerout
Département Systèmes Energétiques et Environnement,
Ecole des Mines de Nantes
, 4 rue Alfred Kastler, BP 10722, 44307 Nantes, Cedex 03, FranceJ. Eng. Gas Turbines Power. Oct 2006, 128(4): 907-914 (8 pages)
Published Online: October 17, 2005
Article history
Received:
October 4, 2004
Revised:
October 17, 2005
Citation
Kumar, M. S., Kerihuel, A., Bellettre, J., and Tazerout, M. (October 17, 2005). "A Comparative Study of Different Methods of Using Animal Fat as a Fuel in a Compression Ignition Engine." ASME. J. Eng. Gas Turbines Power. October 2006; 128(4): 907–914. https://doi.org/10.1115/1.2180278
Download citation file:
Get Email Alerts
Experimental Identification Of Blade Tip Rub Forces At Engine Relevant Temperatures And Speeds
J. Eng. Gas Turbines Power
Study Of Tandem Rotor Dual Wake Interaction With Downstream Stator Under Unsteady Numerical Approach
J. Eng. Gas Turbines Power
Experimental Design Validation of a Swirl-Stabilized Burner With Fluidically Variable Swirl Number
J. Eng. Gas Turbines Power (April 2025)
Experimental Characterization of a Bladeless Air Compressor
J. Eng. Gas Turbines Power (April 2025)
Related Articles
Influence of Injection Timing Variation on Combustion-Emission-Performance Aspects of Emulsified Plastic Oil-Run Compression Ignition Engine
J. Energy Resour. Technol (September,2024)
Comparison of Filter Smoke Number and Elemental Carbon Mass From Partially Premixed Low Temperature Combustion in a Direct-Injection Diesel Engine
J. Eng. Gas Turbines Power (October,2011)
Comprehensive Study on the Effect of CuO Nano Fluids Prepared Using One-Step Chemical Synthesis Method on the Behavior of Waste Cooking Oil Biodiesel in Compression Ignition Engine
J. Thermal Sci. Eng. Appl (August,2019)
An Experimental Way of Assessing the Application Potential of Emulsified Palm Biodiesel Toward Alternative to Diesel
J. Eng. Gas Turbines Power (February,2014)
Related Proceedings Papers
Related Chapters
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Introduction
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Determination of the Effects of Safflower Biodiesel and Its Blends with Diesel Fuel on Engine Performance and Emissions in a Single Cylinder Diesel Engine
International Conference on Software Technology and Engineering, 3rd (ICSTE 2011)