Measurements of the size effect on the nominal strength of notched specimens of fiber composite laminates are reported. Tests were conducted on graphite/epoxy crossply and quasi-isotropic laminates. The specimens were rectangular strips of widths 6.4, 12.7, 25.4 and 50.8 mm (0.25, 0.50, 1.00 and 2.00 in.) geometrically similar in two dimensions. The gage lengths were 25, 51, 102 and 203 mm (1.0, 2.0, 4.0 and 8.0 in.). One set of specimens had double-edge notches and a [0/922]s crossply layup, and another set had a single-sided edge notch and a [0/±45/90]s, quasi-isotropic layup. It has been found that there is a significant size effect on the nominal strength. It approximately agrees with the size effect law proposed by Bazˇant, according to which the curve of the logarithm of the nominal strength versus the logarithm of size represents a smooth transition from a horizontal asymptote, corresponding to the strength criterion (plastic limit analysis), to an inclined asymptote of −0.5 slope, corresponding to linear elastic fracture mechanics. Optimum fits of the test results by the size effect law are obtained, and the size effect law parameters are then used to identify the material fracture characteristics, particularly the fracture energy and the effective length of the fracture process zone. Finally, the R-curves are also identified on the basis of the maximum load data. The results show that in design situations with notches or large initial traction-free cracks the size effect on the nominal strength of fiber composite laminates must be taken into account.
Skip Nav Destination
Article navigation
July 1996
Technical Papers
Size Effect and Fracture Characteristics of Composite Laminates
Zdeneˇk P. Bazˇant,
Zdeneˇk P. Bazˇant
Northwestern University, Evanston, IL 60208
Search for other works by this author on:
Isaac M. Daniel,
Isaac M. Daniel
Northwestern University, Evanston, IL 60208
Search for other works by this author on:
Zhengzhi Li
Zhengzhi Li
Northwestern University, Evanston, IL 60208
Search for other works by this author on:
Zdeneˇk P. Bazˇant
Northwestern University, Evanston, IL 60208
Isaac M. Daniel
Northwestern University, Evanston, IL 60208
Zhengzhi Li
Northwestern University, Evanston, IL 60208
J. Eng. Mater. Technol. Jul 1996, 118(3): 317-324 (8 pages)
Published Online: July 1, 1996
Article history
Received:
June 7, 1994
Revised:
September 17, 1995
Online:
November 27, 2007
Citation
Bazˇant, Z. P., Daniel, I. M., and Li, Z. (July 1, 1996). "Size Effect and Fracture Characteristics of Composite Laminates." ASME. J. Eng. Mater. Technol. July 1996; 118(3): 317–324. https://doi.org/10.1115/1.2806812
Download citation file:
Get Email Alerts
Evaluation of Machine Learning Models for Predicting the Hot Deformation Flow Stress of Sintered Al–Zn–Mg Alloy
J. Eng. Mater. Technol (April 2025)
Blast Mitigation Using Monolithic Closed-Cell Aluminum Foam
J. Eng. Mater. Technol (April 2025)
Irradiation Damage Evolution Dependence on Misorientation Angle for Σ 5 Grain Boundary of Nb: An Atomistic Simulation-Based Study
J. Eng. Mater. Technol (July 2025)
Related Articles
Scaling of Strength of Metal-Composite Joints—Part I: Experimental Investigation
J. Appl. Mech (January,2010)
Single-Edge and Double-Edge Cracks in a Fully Anisotropic Strip
J. Eng. Mater. Technol (October,1999)
Calculation of the Response of a Composite Plate to Localized Dynamic Surface Loads Using a New Wave Number Integral Method
J. Appl. Mech (January,2005)
Scaling of Quasi-Brittle Fracture and the Fractal Question
J. Eng. Mater. Technol (October,1995)
Related Chapters
Introduction and Definitions
Handbook on Stiffness & Damping in Mechanical Design
Determination of Fracture Strength in Orthotropic Graphite-Epoxy Laminates
Composite Reliability
Laminate Strength—A Direct Characterization Procedure
Composite Materials: Testing and Design (Third Conference)