This paper describes the design of an active gravity balanced planar mechanism, where auxiliary parallelograms are used to physically locate the center of mass of the mechanism. A sliding carriage positions a counterweight directly above the center of mass of the mechanism in order to make the system gravity balanced. The sliding carriage uses joint encoder data from the mechanism to compute the location of the center of mass. Experiment results demonstrate the effectiveness of the approach.

Issue Section:
Technical Papers
Keywords:
mechanical engineering, design engineering, mechanical control equipment
Topics:
Center of mass, Chain, Design, Gravity (Force), Manufacturing
1.
Ulrich, N., and Kumar, V., 1991, “Passive Mechanical Gravity Compensation for Robot Manipulators,” Proc. of IEEE Int. Conf. on Robotics and Automation, pp. 1536–1541.
2.
Streit
,
D. A.
, and
Shin
,
E.
,
1993
, “
Equilibrators for Planar Linkages
,”
ASME J. Mech. Des.
,
115
, No.
3
, pp.
604
–
610
.
3.
Walsh
,
G. J.
,
Streit
,
D. A.
, and
Gilmore
,
B. J.
,
1991
, “
Spatial Spring Equilibrator Theory
,”
Mech. Mach. Theory
,
26
, No.
2
, pp.
155
–
170
.
4.
Herder, J. L., and Tuijthof, G. J. M., 2000, “Two Spatial Gravity Equilibrators,” In Proceedings, ASME Design Engineering Technical Conferences, MECH-14120.
5.
Laliberte
,
T.
, and
Gosselin
,
C.
,
1999
, “
Static Balancing of 3 DOF Planar Parallel Mechanisms
,”
IEEE/ASME Transactions on Mechatronics
,
4
, No.
4
, pp.
363
–
377
.
6.
Wang
,
J.
, and
Gosselin
,
C.
,
1999
, “
Static Balancing of Spatial Three Degrees-of-Freedom Parallel Mechanisms
,”
Mech. Mach. Theory
,
35
, pp.
437
–
452
.
7.
Lowen
,
G.
,
Tepper
,
F. R.
, and
Berkof
,
R. S.
,
1983
, “
Balancing of Linkages—An Update
,”
Mech. Mach. Theory
,
18
, No
3
, pp.
213
–
220
.
8.
Fischer, O., 1906, Theoretische Grundlagen fur eine Mechanik der Lebenden Korper, Leipzig.
9.
Auerbach, F., and Hort, W., 1928, Handbuch der Physikalischen und Technischen Mekanik, J. A. Barth, Leipzig, pp. 380–381 (reference to Fischer’s work).
10.
Gokce
,
A.
, and
Agrawal
,
S. K.
,
1999
, “
Mass Center of Planar Mechanisms Using Auxiliary Parallelograms
,”
ASME J. Mech. Des.
,
121
, No.
1
, pp.
166
–
168
.
11.
Gokce, A. 1998, “Center of Mass of Linkages Using Auxiliary Parallelograms,” MS Thesis, Dept. of Mechanical Engineering, University of Delaware.
Copyright © 2001
 by ASME
You do not currently have access to this content.