Skip Nav Destination
Issues
September 2006
ISSN 0090-3973
EISSN 1945-7553
In this Issue
Research Papers
An Internal Conical Mandrel Technique for Fracture Toughness Measurements on Nuclear Fuel Cladding
J. Test. Eval.. September 2006, 34(5): 373–382.
doi: https://doi.org/10.1520/JTE14081
Device Harmonization to Determine Smoothness Specification for Asphalt Pavements
J. Test. Eval.. September 2006, 34(5): 383–389.
doi: https://doi.org/10.1520/JTE100031
Effectiveness of Seal Rejuvenators for Bituminous Pavement Surfaces
J. Test. Eval.. September 2006, 34(5): 390–394.
doi: https://doi.org/10.1520/JTE100056
Evaluation of Residual Stress in Fiber-Textured Films by X-ray Diffraction
J. Test. Eval.. September 2006, 34(5): 395–399.
doi: https://doi.org/10.1520/JTE13113
Hydrophilic Characterization of Automotive Brake Fluid
J. Test. Eval.. September 2006, 34(5): 400–404.
doi: https://doi.org/10.1520/JTE14254
On the Frequency Response of Model Materials in Hydrotechnics
J. Test. Eval.. September 2006, 34(5): 405–409.
doi: https://doi.org/10.1520/JTE14012
Surface Roughness Measurement Using Laser Speckle Statistical Analysis
J. Test. Eval.. September 2006, 34(5): 410–415.
doi: https://doi.org/10.1520/JTE100099
Testing of Rock Climbing Anchors
J. Test. Eval.. September 2006, 34(5): 416–422.
doi: https://doi.org/10.1520/JTE14117
The Formation Mechanism of the Factory-Roof Pattern in a Torsional Fatigue Specimen with Circumferential Notch
J. Test. Eval.. September 2006, 34(5): 423–429.
doi: https://doi.org/10.1520/JTE100101
The Influence of Initial Crack Length on Critical Stress Intensity Factor K1
J. Test. Eval.. September 2006, 34(5): 430–436.
doi: https://doi.org/10.1520/JTE12660
Studying of the Dynamic Behavior of Pile Cushioning Materials in Pile Driving
J. Test. Eval.. September 2006, 34(5): 447–452.
doi: https://doi.org/10.1520/JTE12716
Technical Notes
An Alternative to a 3D Crack Monitor—4-Pin Algorithm
J. Test. Eval.. September 2006, 34(5): 437–439.
doi: https://doi.org/10.1520/JTE11589
Evaluation of Adhesive Strength of Thin Plasma Sprayed Oxide Coatings by a Crosshatch Testing Method
J. Test. Eval.. September 2006, 34(5): 440–442.
doi: https://doi.org/10.1520/JTE14100
Strain Control During High Speed Tensile Testing
J. Test. Eval.. September 2006, 34(5): 443–446.
doi: https://doi.org/10.1520/JTE100073
Email alerts
RSS Feeds
Comparative Evaluation of Outlier Detection Methods for the Asphalt Fracture Tests
J. Test. Eval. (March 2025)
Fatigue Resistance of Unaged and Aged Bio-bitumen: Time Sweep Test versus Linear Amplitude Sweep Test
J. Test. Eval. (March 2025)
Estimation of the Stress-Strength Parameter for a Decreasing Failure Rate Model Based on Ranked Set Samples
J. Test. Eval. (November 2024)
