Friction dampers are utilized in turbomachinery to reduce blade vibrations resulting from aeroelastic interactions. In this paper, the microslip friction model is applied to a blade with blade to ground damper and subjected to negative damping. Analysis using the describing function method, also known as the method of harmonic balance, is used to identify the behavior of the system and the maximum negative damping that can be stabilized by such a damper. These results are compared to those for the macroslip friction model.
Issue Section:
Research Papers
References
1.
Dowell
, E. H.
, 2015
, A Modern Course in Aeroelasticity
, Springer
, Switzerland.2.
Bartels
, R. E.
, and Sayma
, A.
, 2007
, “Computational Aeroelastic Modeling of Airframes and Turbomachinery: Progress and Challenges
,” Philos. Trans. R. Soc., A
, 365
(1859
), pp. 2469
–2499
.3.
Griffin
, J.
, 1980
, “Friction Damping of Resonant Stresses in Gas Turbine Engine Airfoils
,” ASME J. Eng. Gas Turbines Power
, 102
(2
), pp. 329
–333
.4.
Sinha
, A.
, and Griffin
, J.
, 1983
, “Friction Damping of Flutter in Gas Turbine Engine Airfoils
,” AIAA J. Aircr.
, 20
(4
), pp. 372
–376
.5.
Sinha
, A.
, and Griffin
, J. H.
, 1985
, “Effects of Friction Dampers on Aerodynamically Unstable Rotor Stages
,” AIAA J.
, 23
(2
), pp. 262
–270
.6.
Ferri
, A. A.
, and Whiteman
, W. E.
, 2007
, “Free Response of a System With Negative Viscous Damping and Displacement-Dependent Dry Friction Damping
,” J. Sound Vib.
, 306
(3
), pp. 400
–418
.7.
Petrov
, E. P.
, 2012
, “Analysis of Flutter-Induced Limit Cycle Oscillations in Gas-Turbine Structures With Friction, Gap, and Other Nonlinear Contact Interfaces
,” ASME J. Turbomach.
, 134
(6
), p. 061018
.8.
Menq
, C.-H.
, Bielak
, J.
, and Griffin
, J.
, 1986
, “The Influence of Microslip on Vibratory Response, Part I: A New Microslip Model
,” J. Sound Vib.
, 107
(2
), pp. 279
–293
.9.
Menq
, C.-H.
, Griffin
, J.
, and Bielak
, J.
, 1986
, “The Influence of Microslip on Vibratory Response, Part II: A Comparison With Experimental Results
,” J. Sound Vib.
, 107
(2
), pp. 295
–307
.10.
Koh
, K.-H.
, Griffin
, J.
, Filippi
, S.
, and Akay
, A.
, 2005
, “Characterization of Turbine Blade Friction Dampers
,” ASME J. Eng. Gas Turbines Power
, 127
(4
), pp. 856
–862
.11.
Deaner
, B. J.
, Allen
, M. S.
, Starr
, M. J.
, Segalman
, D. J.
, and Sumali
, H.
, 2015
, “Application of Viscous and Iwan Modal Damping Models to Experimental Measurements From Bolted Structures
,” ASME J. Vib. Acoust.
, 137
(2
), p. 021012
.12.
Martel
, C.
, Corral
, R.
, and Ivaturi
, R.
, 2015
, “Flutter Amplitude Saturation by Nonlinear Friction Forces: Reduced Model Verification
,” ASME J. Turbomach.
, 137
(4), p. 041004
.13.
Olofsson
, U.
, 1995
, “Cyclic Microslip Under Unlubricated Conditions
,” Tribol. Int.
, 28
(4
), pp. 207
–217
.14.
Chiang
, D.-Y.
, 1999
, “The Generalized Masing Models for Deteriorating Hysteresis and Cyclic Plasticity
,” Appl. Math. Modell.
, 23
(11
), pp. 847
–863
.15.
Sinha
, A.
, and Griffin
, J.
, 1985
, “Stability of Limit Cycles in Frictionally Damped and Aerodynamically Unstable Rotor Stages
,” J. Sound Vib.
, 103
(3
), pp. 341
–356
.Copyright © 2016 by ASME
You do not currently have access to this content.
